![]() Otherwise, the joint compound will get squeezed out and the paper will not stick to the wall. Don’t press too hard when applying the drywall paper.If you will be putting the drywall tape on the joints and seams, make sure to apply quite a lot of compound to the area (about 1/8th of an inch). Use joint compound to patch up the area.Allow the compound to fully cure, if it was wet, and apply a sealer. ![]() It doesn’t really matter whether the joint compound is wet or dry (the former is messier though and you might end up peeling off more paper than needed). Cut around the bubbles and remove the small section of the paper. Remove the part of the paper with the bubble with the tip of a taping knife or a cutter.A sealer (you can choose not to use one).Remember that any unevenness that you’re going to leave on the wall is going to show up in the end. Instead of trying to cover up the bubbles, you should try to remove them entirely. An extra layer will make the area more prone to cracking. When you notice bubbles on your drywall paper, the first thing that might cross your mind is that applying a fresh layer of compound over the area is a great idea. What Drywall Tape to Use to Avoid Bubbles?.You don’t have to sand in between every single coat. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |